The cable resistance can be a significant factor in the accuracy of the overall measurement. It is very important indeed to consider this point.
Prosig software allows the cable resistance to be entered by the user. Once this resistance has been entered, any calculations or calibrations carried out will be based on the known values of the bridge resistors as well as the resistances of all of the cables.
In most cases this will be negligible except if long cables are used.
Latest posts by James Wren (see all)
- Does the P8000 support strain gauges? And which types? - August 18, 2016
- Example of performing a Moving Average - June 17, 2016
- Is it possible to connect the BNC outer to ground when using a P8000? - April 1, 2015